We purchased a trailer for our bikes to enable us to carry our toddler with us when we go for bike rides. We purchased the Skiidii Bicycle Trailer for $149 on eBay from seller Faji Plaza. The trailer has provision for two small children to ride on it side by side.
The trailer arrived in a flat square box weighing 17kg. We had ours delivered to our Australia Post postbox without any problems. Delivery occurred within a week of order.
On opening the box you find a large folded trailer body, some tubular sections, some wheels and other components. The tools required to assemble the trailer are provided with the kit, a couple of small spanners and an Allen key. I chose to use a socket set and ratchet spanner as this was easier. You’ll need an 11mm hex socket.
At first I thought no instructions were supplied and this made it difficult to figure out how to get the trailer properly assembled. However it turned out the instruction booklet had been wrapped up in the fabric cover for the trailer. Unfortunately, the instructions are pretty badly translated.
I started by unfolding the trailer body and installing the cross bar that supports the roof of the trailer and holds the uprights in the vertical position. It fits together using plastic brackets on each end and some locking pins.
After this I installed the axle(which required adjusting the holes it goes through). The wheels are locked into place with plastic clips that fit into retention grooves at the end of the axle. The diagrams in the assembly guide aren’t too helpful. Wheel protection bars are then connected which go around the outside of the wheels, retained by spring loaded locking pins.
The trailer can be used as a running pram, so either a front wheel or the tow bar can be attached. The tow bar attaches with two locking pins. You can then remove the bike attachment from the tow bar using its locking pin and install it on the bike’s rear axle. You simply remove one of the screws and put it on the axle before screwing it back on. I installed it on the side that didn’t have the gears.
The plastic brackets for the jogging handle are then installed, but I didn’t install the handle as I won’t be jogging with it. An orange safety flag is also provided. The fabric cover is attached with velcro at the front and back and provides a weathershield as well. There is pretty good visibility for your child to be able to see out.
Assembly took me about 45 minutes in total. Once done I attached it to the bike and gave it a try. At first I accidentally knocked the bike over but the trailer stayed upright. I was happy about that. Riding around with the trailer empty it bounces around quite a lot. With our toddler aboard it still bounces a lot but not too badly. The wheel protection bars do rattle a lot however. They don’t fit snuggly into their slots. So while they won’t fall off, they do make a bit of noise. I may look at putting some thin rubber in the slots so they don’t rattle.
The child harness isn’t particularly fancy, just being a strap system. This may be a bit of an issue for younger children. Our baby has no problems walking or sitting up but did tend to end up slumping down on the seat. For larger babies I don’t think this will be a problem.
Overall I’m happy with the Skiidii Bicycle Trailer so far. We haven’t taken it on long rides yet, but will in coming weeks. Build quality is pretty good for the price. The only real issue is the rattling of the wheel protection bars. I’m sure more expensive models would be much more solid. As noted the assembly manual isn’t too good either.
One other issue we did have was finding a suitable helmet. It seems they start at 48cm at the smallest. A smaller one would have been better for us.